Meter Memory; Reviewing Test Results; Reviewing Blood Glucose Day Average Results; Downloading Results Onto A Computer - Glucofast DUO PZN 15405027 Gebrauchsanweisung

METER MEMORY

The Glucofast Duo stores the 1000 most recent blood glucose and HCT test results,
®
dates and times in its memory. To enter the meter memory, start with the meter
switched off.

Reviewing Test Results

1. Press and release M.
" " will appear on the display. Press M again, and the first reading you see is the
last blood glucose and HCT result along with date, time and the measuring mode.
2. Press M to recall the test results stored in the meter each time you press. After
the last glucose test result, press M again and the meter will switch off.

Reviewing Blood Glucose Day Average Results

1. Press and release M. When "
" appears. Release M and then your 7-day average
seconds until the flashing "
result measured in general mode will appear on the display.
2. Press M to review 14-, 21-, 28-, 60- and 90- day average results stored in each
measuring mode in the order of Gen, AC, and then PC.
3. Exit the meter memory. Keep pressing M and the meter will switch itself off after
displaying the last test result.
NOTE:
Any time you wish to exit the memory, keep pressing M for 3 seconds or leave it
without any action for 3 minutes. The meter will switch off automatically.
Control solution results are NOT included in the day average.
50
" appears on the display, keep pressing M for 3

DOWNLOADING RESULTS ONTO A COMPUTER

Data Transmission via Cable

You can use the meter with a USB cable (optional) and the Healthcare Software System
to view test results on your personal computer. To learn more about the Healthcare
Software System or to obtain a USB cable separately, please contact local customer
services or the place of purchase for assistance.
1. Obtaining the required cable and installing the software
You can purchase a standard USB cable commercially. The free Health Care Software
can be found on the TaiDoc website (www.taidoc.com).
2. Connecting to a personal computer
Connect the cable to a USB port on your computer with the meter switched off; con-
nect the other end of the USB cable to the meter data port. "PC" will appear on the
meter display, indicating that the meter is in communication mode.
3. Data transmission
To transmit data, follow the instructions provided with the software. Results will be
transmitted with date and time. Remove the cable and the meter will automatically
switch off.
WARNING:
While the meter is connecting to the PC, it will be unable to perform a test.
51