Setting The Meter - Glucofast DUO PZN 15405027 Gebrauchsanweisung

SETTING THE METER

Before you use your device for the first time, or if you change the battery, you should
check these settings and update them if necessary. Make sure you save the settings
you want after following the steps below.
Entering the Setting Mode
Start with the meter off (no test strip inserted). Press S.
1. Setting the date
The sequence of the date setting is: YEAR -> MONTH -> DAY.
With the YEAR / MONTH / DAY flashing in sequence, press M
to select the correct number. Press S.
2. Setting the time format
Press M to select the desired time format - 12h or 24h. Press S.
3. Setting the time
With the HOUR/MINUTE flashing in sequence, press M until the correct hour/minute
appears. Press S.
4. Setting the buzzer
With the buzzer displays, press M to switch between "On" and "OFF". Press S.
5. Deleting the memory
" on the display, press M and select "no" to keep the results in
With "dEL" and a "
M
memory then press S to skip. To delete all the results, press M and select "YES" to
delete all the memory records.
6. Setting the reminder alarm
Your meter has four reminder alarms. The meter will display "OFF" and "AL1". If you
don't want to set an alarm, press S to skip this step; or press M to select "On", then
press S.
With the hour/minute flashing in sequence, press M to select the correct hour/minute.
Press S and go to the next alarm setting.
42
NOTE:
When the alarm beeps, press M to switch it off. Otherwise, it will beep for 2 minu-
tes then switch off.
7. Setting the backlight
The default setting for meter backlight ("BL") is set to "On". Press M to switch between
"On" and "OFF". Press S.
Congratulations! You have completed all settings!
NOTE:
These parameters can ONLY be changed in the setting mode.
If the meter is idle for 3 minutes during the setting mode, it will switch off auto-
matically.
43