Performing A Blood Glucose Test - Glucofast DUO PZN 15405027 Gebrauchsanweisung

NOTE:
Choose a different spot each time you test. Repeated punctures at the same spot may
cause soreness and calluses.

Performing a Blood Glucose Test

To perform a blood glucose test, you will need: the meter,
one blood glucose test strip, the lancing device and
lancets.
1. Insert the test strip to turn on the meter
Wait for the meter to display the "
2. Select the appropriate measuring mode by pressing M.
3. Obtaining a blood sample
Use the pre-set lancing device to puncture the desired site. The size
of the drop should be at least as big as
microliter (μL) of volume. Gently squeeze the punctured area to
obtain another drop of blood. Be careful NOT to smear the blood
sample.
4. Apply the sample
Gently apply the drop of blood to the absorbent hole of the test strip at a tilted angle.
Confirmation window should be completely filled if enough blood samples have been
applied. Do NOT remove your finger until you hear a "beep" sound.
48
" and " ", and "GLU".
(actual size), which is 1.0
NOTE:
Do not press the punctured site against the test strip or try to smear the blood.
If you do not apply a blood sample to the test strip within 3 minutes, the meter
will automatically turn off. You must remove and reinsert the test strip to start
a new test.
The confirmation window should be filled with blood before the meter begins
to count down. NEVER try to add more blood to the test strip after the drop of
blood has moved away. Discard the used test strip and retest with a new one.
If you have trouble filling the confirmation window, please contact your health care
professional or the local customer service for assistance.
5. Read Your result
The result of the blood glucose test will appear after the
meter counts down to 0. The result will be stored in your
memory automatically together with the HCT value.
6. Remove the used test strip and lancet
Eject your test strip by pushing the eject button on the
side. Use a sharp bin to dispose of used test strips. The
meter will switch itself off automatically.
Always follow the instructions in the lancing device insert when removing the
lancet.
WARNING:
The used lancet and test strip may be biohazardous. Please discard them carefully
according to your local regulations.
Gen
HCT
49