Maintenance - air&me LARY Bedienungsanleitung

MAINTENANCE

CLEANING THE PRE-FILTER: The pre-filter captures dust and extends the appliance efficiency.
It is recommended to clean it every month. Unclip the pre-filter and clean it with warm water
and a soft brush.
CLEANING THE APPLIANCE:
1. Unplug the appliance before doing any manipulation.
2. Do not immerse the appliance into water or any other liquid.
3. Do not use corrosive, abrasive or flammable products to clean the appliance.
4. Use a soft cloth to remove dust at the air inlets and outlets.
5. To avoid calc deposit, clean the tank at least once a month with an appropriate product or
with white vinegar.
STOCKAGE:
To avoid any bacteria or virus proliferation, never store the appliance with water inside the tank
and be sure that the appliance is perfectly dry.
1. Empty and clean the tank.
2. Clean the pre-filter.
3. Store the product in a place that is protected against dust and that is clean and dry.
ACCESSORY (NOT INCLUDED)
In order to empty the tank in a high level
drain, you can easily add the Pump It Up
by air&me lift pump in Lary's tank. Small
and easy to handle, it is easy to install
and enables the dehumidifier to work
independently.
PUMP IT UP
www.airandme.fr/en
14
FAQ
Circumstance Reason
> The product is not correctly
plug or there is an electrical
problem.
> There is a problem on the
The product
does not work electrical system of your
house.
> The tank is full.
> The tank is not properly
placed.
> The pre-filter is dirty what
obstructs the air flow.
> The air inlet or outlet is
obstructed by something.
Drop in the
appliance
performance
(less water in
the tank)
> Temperature is too low.
> Humidity rate is already low.
> Something obstructs the fan.
Abnormal noise
> The product has a
functioning problem.
> Hygrometry sensor problem.
E2 display
> The ambient humidity is less
than 35%. The device stops
LO display
for safety.
> The ambient humidity level
is greater than 95%. The
HI display
device stops for safety.
> The ambient temperature is
below 5°C. The device stops
CL display
for safety.
> The ambient temperature
is above 35°C. The device
CH display
stops for safety.
Solution
> Plug the socket correctly and
check the voltage and the good
functioning of your electrical
system. Avoid multi sockets.
> Empty the tank.
> Push and place the tank properly.
> Clean the pre-filter.
> Leave at least 20cm behind,
around and in front of the
appliance.
> Below 15°C the product works in
Defrost Mode. It cannot therefore
dehumidify to a maximum of its
capacity.
> Make sure that no object obstructs
the air flow.
> Contact your reseller for service
support.
> Contact your reseller for service
support.
> Increase the room humidity rate
with an air humidifier (www.
airandme.fr/en/air-humidifier).
> Increase the room temperature
with a space heater (www.
airandme.fr/en/fan-heater-air).
15