Preparing For Use; Transport And Storage; Assembling The Acoustic Curve - Sigel Sound Balance Montageanleitung Und Gebrauchsanweisung

4

Preparing for use

4.1

Transport and storage

Please note the following points regarding the transportation of the acoustic curve:
Check the packaging for damage if you have ordered it through a transportation services provi-
ƒ
der.
Report any damage during shipment to the transportation services provider and to the retailer
from whom you purchased the acoustic curve.
At least two people should carry the acoustic curve.
ƒ
During transport and when storing the product, do not knock, drop or otherwise apply force to
ƒ
it. This can damage the acoustic curve.
During transport, do not expose the acoustic curve to moisture or extreme temperatures, e.g.
ƒ
frost or heat.
Please note the following when storing the acoustic curve:
Store the acoustic curve in its original packaging for as long as possible.
ƒ
If you no longer have the original packaging, keep the acoustic curve covered during storage.
Store the acoustic curve in a dry, enclosed space to protect it from moisture, direct sunlight,
ƒ
dust and dirt.
If the acoustic curve is going into storage for a long period, disassemble it first.
ƒ
4.2

Assembling the acoustic curve

Warning
`
`
`
1
Fig. 3 Assembling procedure Step 1
The acoustic curve is assembled as follows:
Step 1: Assembly of the 3 elements
1. Stand the middle element of the curve upright with the base at the bottom and hold it firmly
in this position.
2. Place one of the two side elements in a vertical position, also with the base at the bottom.
3. Position the side element so that the connecting edge is directly next to the middle element.
The side element should be approximately 3 cm higher than the middle element.
Carefully slide the side element downwards, ensuring that the connecting pieces on the side
and middle elements interlock smoothly.
Press down firmly on the top of the side element to join both elements securely. Press down
until both elements are at the same height.
Check that both connecting pieces are securely locked in place by gently pulling on the side
element horizontally. If it is loose, repeat the assembly procedure.
4. Attach the second side element as described in steps 2-3.
Sound Balance acoustic curve
The acoustic curve should only be placed on level floors.
After positioning the curve, ensure that it is level and stable.
At least two people are required to assemble the acoustic curve.
Wear gloves while assembling the product to protect the fabric surface of the
acoustic curve from dirt and damage.
2 3 4
15