Disposal Of Linak's Products - Linak DPG1B Bedienungsanleitung

Recommendations on how to use Desk Control
Overriding a learned sedentary behaviour is a true behavioural challenge. We have put together a guide for how
to break up with your chair during your workday.
How to vary between standing and sitting while your work
The most important thing is to vary your position and to move around, preferably three times an hour. Instead
of sitting for too long at a time, you can switch between standing and sitting position. Remember good posture
and to stand with your body weight evenly distributed on both legs.
• Start by raising your desk and standing for 15 minutes each hour before you go to lunch.
• Raise your desk just before your lunch break. Then your desk will be in the right position when you get back
from lunch.
• Just after lunch, stand for 15 minutes before lowering your desk to sit for 45 minutes.
• Raise your desk again every hour, so that you stand up working for 15 minutes each hour for the rest of the
day.
• Raise your desk before you leave for the day – then it is ready for the next day.
Important reservations when varying between standing and sitting position:
If you are pregnant, have varicose veins or have a health condition that may prevent you from standing for 5-15
minutes at a time every hour, you should contact your doctor to make sure that this will not be detrimental to
your health.

Disposal of LINAK's products

As LINAK's customers often ask us how our products can be disposed of or scrapped we have prepared this
guidance that enables a classification to different waste fractions for recycling or combustion.
Guidance
We recommend that our products be disassembled as much as possible and divided into different waste groups
for recycling or combustion.
For example, waste can be sorted into metals, plastics, cable scrap, combustible material and recoverable
resources.
Some of these main groups can be further divided into subgroups; e.g. metal can be divided into steel/
aluminium/copper and plastic can be divided into ABS/PA/PE/PP.
As an example, the table below breaks down the different components in LINAK products to various recycling
groups:
Product
Handset/Control:
By now, almost all our casted plastic parts are supplied with an interior code for plastic type and fibre contents,
if any.
Main groups of disposal
Product main groups
Desk Control App
DPG
Components
Plastic housing
Cable
PCB board
Metal scrap Cable scrap
Recycling group
Plastic recycling or combustion
Cable scrap or combustion
Electronics scrap
Electronics
scrap
X X
Seite 45
Plastic recycling or
combustion
X
Comments