Etl-Marking - Linak DPG1B Bedienungsanleitung

Dpg desk panel und desk control apps

Vorschau ausblenden Andere Handbücher für DPG1B:

Inhaltsverzeichnis

Verfügbare Sprachen

• Statement – for all intentional and unintentional radiators:

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

• Statement for digital devices for Class B:

NOTE: This equipment has been tested and found to comply with the limits for a Class

B diwgital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions it may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/ TV technician for help.

Labeling Requirements:

This Class B digital apparatus complies with Canadian ICES-003.

ETL-marking

Due to space limitations, the complete ETL-marking demands are not represented on the

marking plates. The full ETL Recognized Component markings are shown here.

C/N 120690

Conforms to ANSI/AAMI Std. ES60601-1

Cert. to CSA Std. C22.2 No. 60601-1