Linak DPG1B Bedienungsanleitung Seite 34

Light strip reminder
The light strip is a thin line of LED light shining through the surface of the DPG. The light
strip is intended to indicate the status of the desk user. The status depends on the
reminder interval chosen. When the user is in position in an appropriate amount of time
according to the interval, the light strip calmly pulsates green. When the sitting interval
runs out, the calm pulsating green turns into fast pulsating orange for 1 min hereafter
static orange – this is an indication to the user to adjust the desk to standing height. In
standing height, the light strip will pulsate green until a potential time out. When the desk
is adjusted back to sitting position, the light strip will pulsate green until the reminder goes
off again.
After 4 hours without any action, the light strip will time out. When the DPG is tilted, the
green light will come back on.
Please be aware; When the light strip is enabled for reminders, the DPG is no longer
in ZERO mode as long as the light is on/active.
Figure 5: Pulsating orange light strip indicates the user needs to change position
Factory reset
Pressing and holding the "Memory" and "Reminder" for 8 seconds will set the DPG to factory default. The light
strip will flash red 3 times.
Figure 4: Pulsating green light strip indicates everything is okay
Seite 34