Gps Report; Advanced Operations; Emergency Calls - Kenwood TK-7360 Bedienungsanleitung

■ Reviewing Messages in the Stack
1 Press and hold the key programmed as Stack, Selcall, Status, or
Selcall + Status.
2 Press / (if the key assignment list selection is confi gured as "Enabled") or <B/C> to select
your desired message.
3 Press to return to normal operation.
S /L M
HORT ONG
To send and receive short or long messages, use the Selcall + Short Message or Short Message
functions, or connect the transceiver to a PC. (Ask your dealer for details.)
• Short messages can contain a maximum of 48 characters. Received short messages
are displayed the same as Status messages and are stored in the same stack memory.
A combined maximum of 15 Status calls and short messages can be stored in the stack
memory.
• Long messages can contain a maximum of 4096 characters and can only be viewed via
a PC.
GPS R
EPORT
If a GPS unit (NMEA-0183 format) is installed on your transceiver, you can press the key programmed
as Send the GPS data to send your location data.
E C
MERGENCY ALLS
If your transceiver has been programmed with the Emergency function, you can make emergency
calls.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time
you must hold the Emergency key will vary.
• When the transceiver enters Emergency mode, the transceiver will change to the
Emergency channel and begin transmitting based on how the transceiver is set up.
2 To exit Emergency mode, press and hold the Emergency key again.
• If the Emergency mode completes the preset number of cycles, Emergency mode
will automatically end and the transceiver will return to normal.
■ Lone Worker Mode
Lone Worker Mode is a safety feature built into the transceiver. If the transceiver is not operated
for a pre-programmed period of time, the transceiver will emit a tone and automatically enter
Emergency operation. Operating any key will reset the timer.
Press the key programmed as Lone Worker to toggle the Lone Worker function ON or OFF.
• Depending on the delay time programmed into your transceiver, the length of time
you must hold the Lone Worker key will vary.
• "L-WK ON" momentarily appears on the display when Lone Worker is activated.
ESSAGES

ADVANCED OPERATIONS

13