Priority Scan - Kenwood TK-7360 Bedienungsanleitung

T / R
RANSMITTING
1 Select your desired zone and channel.
2 Press the microphone PTT switch and speak into the microphone to transmit. Release the PTT
switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 ~ 4 cm) from your mouth.
Scan monitors for signals on the transceiver channels. While scanning, the transceiver checks for a
signal on each channel and only stops if a matching signal is present. There are two types of scans
available.
• Single Scan: Monitors the channels of only the currently selected zone. If set up to
scan the Priority channel, it will be scanned even if it is not in the selected zone.
• Multi Scan: Monitors the channels of every zone.
To start/stop scanning, press the key programmed as Scan.
• "SCAN" and the
• When a signal is detected, scan pauses at that channel. The transceiver will remain on
the busy channel until the signal is no longer present, at which time scan resumes.
Note: To use Scan, there must be at least 2 channels added to the scan sequence.
C R
HANNEL ECALL
During scan, you can recall the last zone and channel/group ID on which you made a call by pressing
the key programmed as CH/GID Recall. Scan will remain paused on the Recall channel until you
press the key again.
P S
RIORITY CAN
If a Priority channel has been programmed, the transceiver will automatically change to the Priority
channel when a call is received on that channel, even if a call is being received on a normal channel.
• The icon appears on the display when the Priority channel is selected.
T C
EMPORARY HANNEL
During scan, you can temporarily remove specifi c channels from the scanning sequence by pressing
the key programmed as Scan Delete/Add while Scan is paused at the undesired channel. To
temporarily remove a zone, press and hold Scan Delete/Add while Scan is paused at a channel in the
undesired zone.
• The channel/zone is no longer scanned. However, when scanning is ended and
restarted, the Scan settings return to normal.
ECEIVING
icon appear on the display during scan.
L
OCKOUT
SCAN
7