Niko 10-572 Bedienungsanleitung Seite 27

6. PROGRAMMING AND CHANGING SETTINGS
6.1. Setting the ring tone and volume
You can set up a different ring tone for each type of call. The device offers a selection of 13 different ring tones.
1. Press the menu key in stand-by mode
The call settings menu will appear (fig. 5).
2. Press the menu key once again
3. Use the navigation keys to change the set value.
4. After 10 sec. the menu automatically switches off and the device returns to stand-by mode.
6.2. Adjusting the image settings
It is possible to change the contrast, brightness and colour intensity of the image.
Press the camera key or the
1. Press the menu key .
The menu image settings will appear (fig. 6).
2. Press the menu key once again
3. Use the navigation keys to change the set value.
4. After 10 sec. the menu automatically switches off and after 1 min. the device returns to stand-by mode.
6.3. Programming with the service set
To assign the internal video unit to a bell push button as a first or second device, check the manual of the power supply (10-80X) or the service unit (10-870).
To assign the internal video unit to a bell push button as a third or fourth device, connect the device in parallel (as a slave) with another internal unit.
Tip: For easy programming, it is recommended that you attach the serial numbers of all internal and external units that are part of the installation onto the wiring
diagram. The serial numbers can be found on the packaging and on the device. The serial number of this internal unit can be found inside the upper frame.
1. Connect the service unit to the external unit using terminals a, b and P, or using the designated connector.
2. Enter the key combination onto the service unit depending on the type of action you wish to perform.
Attention: Only one of the four functions (90, 91, 92 or 93) per internal video unit can be programmed.
Action
Look up internal unit
Programming the call diversion
Programming the ring-and-come-in function
Programming internal call
Activating control function 8 for the DIN rail relay
Connecting internal unit as slave to a master (parallel connection)
Deactivate programming of master and slave
6.4. Assigning a ring tone to a specific bell push button
It is possible to set a different ring tone per internal unit for up to 5 bell push buttons. That is because the internal unit will also react to the four serial numbers
that follow its own serial number. When a call comes in, you can thus hear who it is for or where the call is being made from (e.g. practice-private, parents-
grandparents, etc.)
Program the installation with the service device (10-870) as follows:
Bell push button 1 Serial number
Bell push button 2 Serial number +1
Bell push button 3 Serial number +2
Bell push button 4 Serial number +3
Bell push button 5 Serial number +4
EN
.
to go through the settings.
speech key in stand-by mode to activate the camera image.
to go through the settings or to confirm the new setting.
Ring tone
Ring tone
Ring tone
Ring tone
Ring tone
Key combination
* 52 #
* 90 # serial number internal unit # serial number internal unit for diversion #
Use the free function key to activate this function (§ 4.1)
* 91 # serial number internal unit #
Use the free function key to activate this function (§ 4.1)
* 92 # serial number internal unit # serial number internal unit to be called #
Use the free function key to activate this function (§ 4.1)
* 93 # serial number internal unit #
Use the free function key to activate this function (§ 4.1)
* 99 # serial number internal unit # serial number master #
* 99 # serial number internal unit # 0 #
10-572 / 10-573
27