Columbus TA 50 K 50 Bedienungsanleitung Seite 15

In this modality the machine works as a classical extractor. After filling the tanks with solution and
inserting the plug in the wall outlet (see steps 1 and 2 of the paragraph Preparation for Work), you
need to perform the following operations:
1. Connect the machine to the wand or to the hand-tool using the solution and the vacuum
hoses. To connect the hoses to the machine, remove the vacuum hose, which connects the
upper tank to the vacuum shoe, and the solution hose, which connects the pump to the 5
spraying nozzles, situated under the machine. By doing so, TA 50│K 50 becomes a classical
extractor.
Solution pipe
2. Switch on the vacuum motor by setting their switch to position "I", and the pump by setting the
switches to position "II". In this way the solution pump always works and it is not necessary to
keep pressed the control lever situated on the control panel.
3.
To spray water you need to press the lever situated on the handle of the accessory.
Use with Accessories
15
TA 50│K 50
Vacuum hose