Replacing The Centre Brush - Portotecnica Genius 1300 DP Gebrauchs- Und Bedienungsanleitung

REPLACING THE CENTRE BRUSH

Caution: this operation must be carried out with the machine off
and the key removed.
This machine features a system for automatically adjusting the
pressure exerted and compensating for wear.
The code 'F500' will come up on the display to indicate that the
centre brush needs to be replaced.
To replace the centre brush, proceed as follows:
Open up the door on the left hand side of the machine by
loosening the knob, as shown in the figure.
Unscrew and remove the three knobs that secure the cover of
the brush compartment in place.
Remove the cover of the brush compartment.
English
Remove the worn brush.
Remove the adapter of the brush stem and fit it onto the new
brush. Maintain the same inclination of the bristles.
(See the next figure).
Refit the adapter and mount the new brush. Make sure the
adapter is inserted into the hub.
- 22 -