Before Starting The Equipment; Operation - EINHELL BT-CW 18i Bedienungsanleitung

Anleitung_BT_CW_18i_SPK1:_
GB
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 89,5 dB(A)
pA
K uncertainty
pA
L sound power level 100,5 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Tightening screws and nuts of maximum
permitted size
Vibration emission value a = 5,67 m/s 2
h
K uncertainty = 1,5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.

5. Before starting the equipment

Charge the battery pack only with the charger
supplied.

6. Operation

6.1 Charging the battery pack (Fig. 2/3)
1. Take the rechargeable battery pack out of the
handle (Fig. 2), pressing the pushlock buttons at
the side to do so.
2. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket.
3. Plug the battery pack into the charging adapter.
The LED (a) will come on to indicate that the
battery pack is being charged. The temperature
of the battery pack may rise slightly during the
charging operation. This is normal.
Important! The battery charger does not
switch off automatically when the battery is
fully charged.
10
11.03.2008 14:30 Uhr
If the battery pack fails to become charged, please
check
whether there is voltage at the socket-outlet
whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
3 dB return
the charger
the battery pack
3 dB
to our Customer Service Department.
To ensure that the battery pack provides long service,
you should take care to recharge it promptly. You
must recharge the battery pack when you notice that
the power of the hammer screwdriver drops. Never
fully discharge the battery pack. This will cause it to
develop a defect.
6.2 Changeover switch (Fig. 4/Item 3)
Using the slide switch above the ON/OFF switch you
can select the direction of rotation of the hammer
screwdriver and lock the screwdriver so that it cannot
be switched on accidentally. You can select between
clockwise and counter-clockwise rotation. In order to
avoid causing damage to the gearing, the direction of
rotation must only be changed when the screwdriver
is at a standstill. When the slide switch is in the
middle position, the ON/OFF switch is blocked.
6.3 ON/OFF switch (Fig. 4/Item 4)
Infinitely variable speed control is possible with the
ON/OFF switch. The further you push the switch, the
higher the speed of the cordless hammer
screwdriver.
6.4 Tightening screws / nuts (Fig. 5)
Plug the required drive socket insert on the square
drive mount. Select the correct direction of rotation
on the hammer screwdriver. Push the drive socket
insert onto the screw head and actuate the ON/OFF
switch.
For as long as the screw / nut is untightened, the tool
works as a normal screwdriver. Only when the screw
/ nut is tightened does the tool work as a hammer
screwdriver.
It is imperative that you use a torque wrench to
check a torque which has been specified by a
manufacturer. In doing so, ensure that you observe
the information supplied by the manufacturer in the
directions for use.
Most mounting parts can be tightened within a few
seconds. The time required to achieve the maximum
torque depends on the actual case of application and
can be determined with experience.
Seite 10