Herunterladen Inhalt Inhalt Diese Seite drucken

Operating; Prior To First Use - Bartscher 700 series Bedienungsanleitung

Für 2/1 gn roste
Vorschau ausblenden Andere Handbücher für 700 series:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Set up the device using the adjustable legs. Use a level as needed. Every leg must
touch the floor, as otherwise the door may open and close improperly.
Remove the protective foil from the device.
Not at any time should you place the device on an inflammable surface.
Do not place the device in the vicinity of open sources of fire, electric cookers,
furnaces or other sources of heat such as e.g., in places exposed to direct sunlight.
The heat can damage the surface of the device, as well as have a negative effect on
the cooling power and increase the consumption of energy.
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
Place the device in such a manner that there is a minimum of 10 cm between it and
other objects, including walls, in order to ensure proper air circulation.
Place the device in such a manner that the ventilation ducts are neither blocked or
covered.
Do not place the device where humidity or temperature are high as the device may
be damaged.
Before the first use the device should stand for at least 2 hours before it is connected
to the power source.
Do not drill holes in the device nor mount other objects to it.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

Prior to first use

Wash the device after unpacking and before connecting to an electrical outlet
(see 6.2 Cleaning).
Connect the device to a single, grounded socket.
Turn the device on using the ON/OFF switch at the front.
Prior to placing food products inside the device, allow the deep freezer to reach the
desired temperature.
- 29 -

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

700.475700.495

Inhaltsverzeichnis