Kirami Original Woody Bedienungsanleitung Seite 26

26/68
The first use
In external stoves (CUBE and TUBE) the water circulation of the stove shall be rinsed by letting
plenty of water in from the pipe above, so that any metal chips from grinding come out. Collect any
trash by swiping it off the bottom of the tub. When you fill the tub, check the fastening pipes of the
stove for any leakages.
LIGHTING AND USING THE STOVE
Use smaller and dry kindling wood for igniting the fire and then add bigger pieces as needed every
10 to 15 minutes. Maintain the fire in the stove during heating, so that the wood will burn properly
and the tub will heat with maximum power. If the fire is too small, the heating time becomes
remarkably longer.
Empty the ashes from the stove after every use, so that the air slides will not be covered by ashes,
because it will make their life shorter.
Use only small, dry firewood in the stove. The use of larger and damp firewood may double the
heating time and it will also generate a lot of smoke. We do not recommend black alder because it is
sootier than other wood. It is advisable to adjust the air intake of the stove according to the type
and size of the wood, so as to reduce the amount of smoke.
Use lighter fluid according to the instructions. Do not use any other fuels for lighting. We
recommend lighting pieces, e.g. Burner paraffin bags.
Cold water and warm air (temperature difference/air humidity) often cause condensed water in the
ash collector and, therefore, the stove is not leaking although there is some water in the furnace.
You can suspect a leakage only if the water level is going down.
During heating, the tub should be covered in order to limit heat evaporation as much as possible.
The water temperature should be measured every 20 minutes during heating. Because water
stratifies into layers when it warms up, it should be mixed with a Kirami paddle, for example. When
the temperature reaches approx. 32°C, it is advisable to reduce the amount of firewood added so as
to avoid overheating the tub. When the desired temperature has been reached, you may keep a
small fire under the tub where necessary to sustain the temperature. Practice makes perfect in this
as in anything else.
It is advisable to open the cover about 5 minutes before getting in the
bath to allow the water to settle. For reasons of safety and heat
evaporation, the cover should be closed as soon as possible after taking
a bath, especially if you intend to use the tub the next day.
The use of CUBE, TUBE, and SIDE stoves is as easy as using any other
normal furnace. The draught can be adjusted with a grate in the mouth
hatch, loosen and tighten the fastening on the button by turning it
before you move it, and tighten to the desired position.
When lighting the SUB built-in stove, good firelighters and wood chopped
small are essential. Ensure also that the exhaust goes in the right direction
and the smoke and flames do not hit out of the hatch. The direction of the
draught can be helped by blowing air to the opening of the air slide or by
INSTRUCTIONS FOR USE: Kirami Original Woody 6 / 9
27.02.2016