Dmx-Controlled Operation; Addressing; Dmx-Protocol - Futurelight Eye-90 Rgb Bedienungsanleitung

RST - Reset Function
This option enables the EYE-90 to index all effects (functions) and return to their standard positions.
•
Press the Mode button and select „RST".
•
Press the Up button to select "y" if you wish to enable this function or press the Down button to select
"n" if you don't.
•
Press Enter to confirm.
DIS - Display-reverse
With this function, you can rotate the display by 180°.
•
Press the Mode button and select „DIS".
•
Press the Up button to select "y" if you wish to enable this function or press the Down button to select
"n" if you don't.
•
Press Enter to confirm.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the EYE-90 will respond to the controller.
If you set, for example, the address to channel 13, the EYE-90 will use the channel 13 to 24 for control.
Please, be sure that you don't have any overlapping channels in order to control each EYE-90 correctly and
independently from any other fixture on the DMX-chain.
If several EYE-90 are addressed similarly, they will work synchronically. Press the Up/Down-buttons for
setting the desired starting address.
Controlling:
After having addressed all EYE-90, you may now start operating these via your lighting controller.
Note:
After switching on, the EYE-90 will automatically detect whether DMX 512 data is received or not. If the data
is received, the control LED flashes. If there is no data received at the DMX-input, the control LED does not
flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of EYE-90.
- the controller is switched off or defective.
- the cable or connector is defective or the signal wires are swap in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control-channel 1 - Horizontal movement (PAN)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (TILT)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
25/28 00049502.DOC, Version 1.1