Connection With The Mains; Operation; Display And Function Buttons - Futurelight Eye-90 Rgb Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

With the POWER-switch, you can switch the device on and off.
After you connected the effect to the mains, the EYE-90 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.

Display and function buttons

•
Press the Mode button and select from the functions:
A001 - DMX 512 Address settings:
Use the Up and Down buttons to select required address and press Enter to confirm or Mode to cancel and
return to the main menu.
RE-1 – Software version
With this function you can display the software version of the device.
PAN - PAN Reverse
With this function you can reverse the PAN-movement.
•
Press the Mode button and select „PAN".
•
Press the Up button to select "y" if you wish to enable this function or press the Down button to select
"n" if you don't.
•
Press Enter to confirm.
TIL - TILT Reverse
With this function you can reverse the TILT-movement.
•
Press the Mode button and select „TIL".
•
Press the Up button to select "y" if you wish to enable this function or press the Down button to select
"n" if you don't.
•
Press Enter to confirm.
DEM - Demo operation
In the Stand Alone mode, the EYE-90 can be used without controller. Disconnect EYE-90from the controller
and call up the internal program.
•
Press the Mode button and select „DEM".
•
Press the Up button to select "y" if you wish to enable this function or press the Down button to select
"n" if you don't.
•
Press Enter to confirm.
International
L
N
24/28 00049502.DOC, Version 1.1