hanseatic HGS 8555A2 Gebrauchsanleitung Seite 44

Page EN-18 Start-up
7. Place the cover back onto the freezer,
ensuring that the temperature controller 1
fits in the designated opening again. Push
down on both sides (left and right) of the
front of the cover until you hear it click into
place.
8. Screw the two screws tightly back onto
the cover. To do this, use a cross-head
screwdriver. Secure the two screw cov-
ers.
9. Tip the freezer backwards (maximum
45°) so that you can also move the lower
door hinge.
10. Unscrew both front levelling feet.
11. Unscrew the lower hinge plate. To do
this, use an 8 mm spanner or a cross-
head screwdriver.
1.
12. Turn the hinge plate. Loosen the hinge
bolts with a 10 mm spanner. Loosen the
screws and reinsert the screws and the
hinge bolts from the other side.
13. Screw the hinge plate tightly back onto
the opposite side. Make sure that the
hinge pin is in the hinge bushing of the
door.
The door will now function properly
again.
14. Screw both adjusting feet securely back
onto the freezer.
15. Carefully stand the freezer upright.
16. Reinsert the blind plug on the opposite
side of the door.