Instrument Security - Welch Allyn SureTemp Plus series Handbuch

INSTRUMENT SECURITY

The SureTemp Model 692 thermometer is equipped with electronic security
options designed to reduce the risk of theft. These options include both
Temperature Count and Instant-On security features.
TEMPERATURE COUNT
The Temperature Count security feature allows you to take a set number of
temperature readings before the instrument goes into the security alarm state.
The selectable counts are 25, 50, 100, and 200. As the instruments nears the final
reading, it will display SECURITY COUNT as a warning, along with a number
representing the last 5 temperature counts (i.e., 5,4,3,2,1) remaining on the
security counter.
When the instrument enters the alarm state, it beeps for approximately 10
seconds. At this time, the instrument displays SEC on the LCD along with
SECURITY COUNT in the ID field in the upper left-hand corner of the screen. The
instrument is then disabled. Returning the instrument to the wall holder resets
the security count. If the count is set to "OFF" the temperature count function is
disabled and no security alarm will occur
To set the Temperature Count security feature, please refer to the Technical
Manual.
INSTANT-ON
When the Instant-On feature is activated, the instrument goes into the security
alarm state within five seconds after removal from the wall holder. When the
instrument enters the alarm state, it beeps continuously and displays SEC on the
LCD. Pressing the Mode Selection button while removing the probe from the
probe well, within 30 seconds of the instruments removal from the wall holder,
clears the alarm and allows the instrument to operate. Returning the instrument
to the wall holder will reset the instant audio alarm.
The options for the Instant-On feature are ON and OFF . In the OFF setting, no
security alarm will sound.
To set the Instant-On security feature, please refer to the Technical Manual.
1-20