Button Functions; Set-Up; Assembling The Unit - Welch Allyn SureTemp Plus series Handbuch

BUTTON FUNCTIONS

Buttons
C/F
Pulse Timer
(692 Only)
Mode Selection
Recall

SET-UP

ASSEMBLING THE UNIT

Your SureTemp Plus thermometer is shipped to you with three 1.5V AA batteries
installed.
1. Install the oral/axillary probe (blue ejection button) or optional rectal probe
(red Ejection button) by inserting the latching probe connector on the end of
the coiled cord into the unit's plug receptacle. Ensure that the connector
snaps into place. The LCD will illuminate for approximately 7 seconds and
will then turn off.
Procedure
Press and release the C/F (Celsius/Fahrenheit)
button to toggle between temperature scales any
time a temperature is displayed on the LCD.
Press and release the Pulse Timer button to activate
the timer. Audible beeps sound at 0, 15, 30, 45, and
60 seconds. The timer turns off automatically after 60
seconds. You can stop the timer at any time by
pressing the Pulse Timer button or by removing the
probe from the probe well.
Press and release the Mode Selection button after
you have withdrawn the blue probe from the probe
well to change the current measurement site to Oral,
Adult Axillary, or Pediatric Axillary. The selected
measurement site is displayed by a flashing body site
icon. Note that no other measurement sites are
available when using the red probe in the Rectal
Mode.
Press and release the Recall button when the display
is blank to recall the last completed predicted
temperature. The LCD will display the recalled
temperature for five seconds along with the battery
icon, temperature scale, mode selection, and probe-
position icon (if applicable).
1-7