Becker Centronic SunWindControl SWC441 Bedienungsanleitung Seite 15

Operating Instructions
Group
Group control means controlling one or several receivers at the same time. The
programmed group is activated using a single command.
Wind threshold control switch
This control switch allows you to set the wind threshold values (approx. 2m/s to 22
m/s).
The wind threshold value can be set to 11 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: retract when wind speed is low
+ Right limit stop = Level 11: retract when wind speed is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold value.
If the wind speed rises above the preset wind threshold, the sun protection
system is retracted and remains closed. The sun protection system is extended
again if the wind speed remains below the preset wind threshold for approx.
15 minutes.
Sun threshold control switch
This control switch allows you to set the sun threshold values (approx. 5KLux to
50KLux).
The sun threshold value can be set to 15 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: extend when sun intensity is low
+ Right limit stop = Level 15: extend when sun intensity is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold value.
If the sun intensity rises above the preset sun threshold, the sun protection
system is extended after approximately 1.5 minutes. The sun protection sys-
tem is retracted again automatically if the sun intensity remains below the
sun threshold for approx. 15 minutes.
15