Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection
•
The equipment must be connected to a mains socket that has an earth contact.
•
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
•
Lay all connection cables so that they do not present a trip hazard.
•
Whenever working on the equipment switch off all inputs and outputs to the power supply.
•
Check whether the connection figures comply with the existing mains supply. Serious damage could occur due
to connecting the system to the wrong power supply. An incorrect mains voltage could damage the equipment
or cause an electric shock.
•
Please note that different operating voltages require the use of different types of power cable and plugs.
Please refer to the following table:
Voltage
Power plug according to standard
110 - 125 V
UL817 and CSA C 22.2 no 42.
220 - 230 V
CEE 7 page VII, SR section 107-2-D1/IEC 83 page C4.
240 V
BS 1363 (1984): "Specification for 13A fused plugs and
switched and un-switched socket outlets."
•
If the equipment causes a blown fuse or a short circuit, disconnect it from the mains and have it checked and
repaired.
•
Do not hold the mains cable with wet hands. There must be no water or dust on the contact pins. In both cases
you could receive an electric shock.
•
The mains cable must be firmly connected. If it is loose there is a fire hazard.
•
Always pull out the mains cable from the mains and/or from the equipment by the plug – never by the cable. The
cable could be damaged and cause an electric shock or fire.
•
Do not use the equipment if the mains plug is damaged.
•
If you connect defective or unsuitable accessories, the equipment could be damaged. Only use connection
cables available from or recommended by beyerdynamic. If you use cables you have made up yourself, all claim
to warranty is null and void.
Maintenance
•
Only clean the equipment with a slightly damp or dry cloth. Never use solvents as these damage the surface.
Trouble shooting and servicing
•
Do not open the equipment without authorisation. You could receive an electric shock. There are no user-
serviceable parts inside.
•
Leave all service work to authorised expert personnel.
Headphones
•
With wired headphones you should avoid sharp movements, which could cause the headphone to fall off your
head. You could be seriously injured especially if you are wearing pierced earrings, spectacles etc. The cable
could wind around your neck and cause strangulation.
•
When connecting the headphone please ensure that the volume is turned down to minimum. Adjust the
volume after putting on the headphone. Do not set the volume too high, as you could permanently damage
your hearing.
- 11 -
Werbung
Inhaltsverzeichnis
