Gewa DP340G Schnellstartanleitung Seite 38

ASSEMBLY INSTRUCTIONS
DP340G
NOTE
38
ASSEMBLY INSTRUCTIONS
This section tells you how to correctly set up your digital piano. For assembly you will
need:
• A size 2 phillips screwdriver
• Another person
Do not tighten the phillips screws until all parts of your digital piano have been pre-
assembled and aligned.
How to assemble your digital piano:
1. Unfold the pedal cable (not shown) and screw the adjustment screw ( 13 ) into the
pedal board ( 4 ).
2. Connect the side panels (5 and 6) with the pedal board using the phillips screw (7b)
3. Now insert the pedal board brace ( 2 ). Make sure that the pedalboard is inserted
into the groove provided. Then attach it to the side panels with 4 screws (9a) and
2 screws (9b) in the middle of the brace.
4. Then fix the back panel brace (3) with phillips wood screws as well (9a).
5. Then you can attach the keyboard from above. For stability, this must rest evenly on the
fixed angles on the side panels. Then the keyboard (1) must be connected and fixed
with the four phillips screws (8b).
6. Now screw the headphone hanger (12) on to the left underside of the keyboard by
using the phillips screw ( 8a )..
7. Then align your digital piano and tighten all the screws.
8. Finally, fit the rubber covers (11) into all holes in the side panels ( 5 and 6).
9. Place your digital piano at the desired location and make sure that the adjustment
screw ( 13 ) touches the floor as shown below.
DP340G