Troubleshooting; Patents And Trademarks - Whale Orca Auto 1300 Montagehandbuch Und Bedienungsanleitung

If the fuse blows:
a) Check that all system valves/stop cocks are open
b) Check that the inlet and outlet ports are not blocked
c) Check that the rest of the system is not blocked
d) Check for reverse polarity connection
10. MAINTAINENCE
This Whale Orca Auto 1300 is designed to only require minimal maintenance.
Annual Checks
• Whale advise that the boat's plumbing system is checked at least annually for
leaks and obstructions. Also an electrics check including testing the pump is
advisable.
Optimal Performance
• Ensure this product is clear of debris
WARNING: Do not use abrasive cleaners.

11. TROUBLESHOOTING

PROBLEM
Pump runs but
does not pump
water / pulses
Pump does not run
Motor speed variation
when running dry

12. PATENTS AND TRADEMARKS

Whale® is registered trademark to Munster Simms Engineering limited (also trading
as Whale® Water Systems)
13. WARRANTY STATEMENT
This Whale® product is covered by 1 year warranty - Please see enclosed document
for details of our statement of limited warranty
14. DECLARATION OF CONFORMITY, STANDARDS, APPROVALS
This product complies with all relevant European directives and standards. Please
contact Whale® if further details are required.
Copyright Whale 2012- All rights reserved.
WHALE®, is a registered trademark of Munster Simms Engineering Limited, Bangor
Nortern Ireland trading as Whale. Whale's policy is one of continuous improvement
and we reserve the right to change specifications without prior notice. Illustrations are
for guidance purposes only.
POSSIBLE CAUSES
Hose may have
blockage or airlock
Impeller may be
restricted
Blown fuse
POTENTIAL SOLUTION
Clear the hose of any blockages and ensure that outlet
hose runs upward to the thru-hull connector, with no
Remove pump housing from base. Remove debris from
chamber and impeller. Ensure that the impeller is firmly
attached to shaft and is not cracked or broken
Ensure electrical connections and fuse are waterproof
and have not loosened
Normal operation
dips