Nikon Lite Touch Zoom 100ED Bedienungsanleitung Seite 43

Problem
No indicator
appears even
when the camera
is turned on.
The numeral " "
does not appear
even when film is
loaded.
The shutter
cannot be
released using
the remote
control.
A characteristic of electronic cameras
In rare cases, when strong static electricity or the like is applied to
the camera, the camera may not work properly.
If this happens, remove the battery and reinstall it.
When the battery is removed, the date/time are reset. Set them
after reinstall the battery. (
Check points and solution
a The battery is installed with wrong polarities.
Install it with the correct polarities.
a No battery or dead battery.
Install a new battery.
a The letter " " blinks or lights up.
Remove the film and load it again.
a You are out of the remote control working range.
Operate the remote control in a range within
5 m facing the camera.
a Two or more minutes have elapsed since you set
the camera to Remote Control mode.
Set the camera to Remote Control mode again.
a The remote control is operated in backlit.
Change the position of the remote control.
a The service life of the battery in the remote
control has lapsed (10 years).
Visit an authorized Nikon dealer or service
center to change it (at your expense).
p. 41)
Additional Information
Ref. page
12
12,13
14,15
39
39
E
39
—
43