Solvis SolvisMax Futur Montageanleitung Seite 10

SolvisMax Futur / SolvisMax Solo – Installation
Assembly of the unit (part 1)
Futur / Solo
1. Installing the storage tank
• Remove the console brackets and floor levelling pack
from the container and place to one side for later as-
sembly.
• Install the storage tank so that there is approx. 30cm
clearance to the side of and behind the unit to be able
to close the storage tank insulation at the rear if re-
quired later.
• Align the container vertically. Use the supplied floor
levelling plates when installing the storage tank.
2. Mounting the console brackets
• Mount the four console brackets on the storage tank
(see arrows).
3. Mounting the flange insulation
a) Rear flange insulation
• Carefully pull apart the lower flange insulation and posi-
tion around the flange.
• Place the fastening strap around the insulation and
close it with the fastener so that it is tight on the
flange.
10
Mounting the console brackets
Putting on the rear flange insulation
M 30-M – Subject to technical changes 05.07