Emptying The Tank And Cleaning The Cyclonic Fi Lters - aldes C.AXPIR Installations- Und Wartungsanleitung

3.2. Emptying the tank and cleaning the cyclonic fi lters
Caution: The unit must be unplugged before removing the tank.
Remove the tank using the side handles and withdraw the fi lter block as indicated below.
3.2.1. Tank
3.2.2. Filters
The HEPA and PRO-TECTA fi lters can be washed and re-used. They can be washed with water and neutral soap.
The fi lters must be completely dry before being put back.
The HEPA fi lter must be replaced if damaged or after two washes.
The PRO-TECTA fi lter must be replaced if damaged or after fi ve washes.
For C.Axpir Digital: once the fi lters replaced in the correct position, reset the HEPA indicator:
Press the MODE button until the indicator of HEPA fi lter appears, then press the RESET button and maintain
pressed for 10 seconds before disconnect the device from the power supply, then reconnecting.
1. Detach the tank by pulling the handles upwards
2. Remove the cyclonic cone
3. Empty the tank
4. Follow procedure 3.2.2 if your fi lters are clogged
5. Make sure that the cyclonic cone is reinserted
correctly before putting the tank back
19
EN