Installation; Tabletop Operation - Siemens SISTORE CX4 series Inbetriebnahmeanleitung

Installation

7 Installation
7.1

Tabletop operation

10
Siemens Building Technologies
Fire Safety & Security Products
Overheating of the device
In case of overheating the device will shut down automatically.
All 4 LEDs on the front of the device will be lit red.
1. Pull the power plug and allow the device to cool down.
2. Wait for at least 2 hours for the device to cool down.
IMPORTANT
3. Check to ensure there is a minimum clearance of 85 mm on both sides of the
device.
4. Measure the ambient temperature. See Section:
3 Technical data.
5. Connect the power plug again.
6. Then restart the device.
1. Stick the rubber feet (scope of supply) into the four indentations on the bottom
of the device.
2. You can place up to three devices on top of each other.
3. The device must be installed with a minimum clearance of 85 mm on both
sides.
03.2009