Multiple-Device System - Siemens SISTORE CX4 series Inbetriebnahmeanleitung

8.2

Multiple-device system

Siemens Building Technologies
Fire Safety & Security Products
1-4 cameras
1-4 cameras
1-4 cameras
Fig. 4 Multiple-device system
Fig. 5 SISTORE CX4 connections
1. Place the device on a desk or table or install it in a rack. See Section:
7.1 Tabletop operation and Section: 7.2 Rack installation.
2. Connect the cameras (max. 4) to the video inputs (
3. If loop-through is necessary, set the terminating resistor (
the video cable extension to the video loop (
4. Connect all the SISTORE devices to the network switch (
5. Connect one or more client PCs to the network switch using the network cable
provided.
6. Connect the monitors to the client PCs.
7. To display the IP address of a SISTORE CX device, connect an analog
monitor to the appropriate device (4).
8. Connect the power supply unit to the SISTORE (
source.
9. Switch on the analog monitor.
After a short wait, the IP address of the SISTORE CX4 will appear on the
screen.
10. Connect the client PC to the power supply.
11. Start the client PC.
12. Set the IP address of the client PC. See Section: 8.4 Setting the IP address of
the client PC.
Network Switch
SISTORE CX4
SISTORE CX4
•
•
•
SISTORE CX4
Client-PC
SISTORE CX4 Analog Monitor
).
1
) to Off and connect
2
).
3
).
10
) first and then to the power
13
Setup
13
03.2009