Description Of The Device; Leds; Led Indicators In Exceptional Cases - Siemens SISTORE CX4 series Inbetriebnahmeanleitung

Description of the device

6 Description of the device
6.1

LEDs

8
Siemens Building Technologies
Fire Safety & Security Products
LED indicators of video status during device startup
1 Video status
line per channel
2
(input)
3
4
LED displays while online
1 Video status
line per channel
2
(input)
3
4
5 Network
6 Hard disk
7 Power

LED indicators in exceptional cases

1 Video status
line per channel
2
(input)
3
4
All LEDs off: Connection of the device (approx. 30 sec
following initial start-up) or
Device is ready for operation
LEDs lighting green Initializing the device
in sequence:
Checking the hard disk (this may take quite
some time if the device was not shut down
properly)
All LEDs showing The video processor is being installed
red: (approx. 12 sec)
No indicator: No camera connected
Red: Alarm, initializing, overheated
Green: Receiving camera signal
Orange: Live image or recording
No indicator: No connection to the network
Lit green: Connected to the network
Blinking green: Data transmission
No indicator: No access to internal hard drive(s)
Blinking green: Access to internal hard drive(s)
Lit green: Power supply
All LEDs flashing red: Re-initializing the device following a factory
reset (if a large number of recordings are stored
on the device this may take quite some time)
Then the device boots up again.
All LEDs flashing Device shutting down following a reboot.
orange Then the device boots up again.
LEDs lighting orange Device shutting down following a restart.
in sequence: Then the device boots up again.
All LEDs showing red: Overheating of the device
Device shutting down.
The device boots up again when it has cooled
down.
03.2009