Use - Electrolux EFC6423 Bedienungsanleitung

12 www.electrolux.com

USE

The hood can be switched on pushing directly onto the requested speed without firstly having
to select 0/1 button
Button Led
L
-
T1
Fixed
T2
Fixed
T3
Fixed
T4
Fixed
S1
Fixed
Flashing
S1
L T1
Function
Turns the lights on/off at maximum strength.
Turns the motor on/off at speed one.
Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, with all the loads turned
off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The rele-
vant LED flashes twice to confirm.To turn the alarm off, press the button again
and hold for at least 3 seconds. The relevant LED flashes once.
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned
off (Motor and Lights), to perform a reset of Filter saturation alarm. The LED S1
flashes three times.
Turns the Motor on at INTENSIVE Speed.This speed is timed to run for 10 mi-
nutes. At the end of this time, the system returns automatically to the speed that
was set before. If it is activated with the motor turned off, the hood will switch to
OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control, indicated by the LED
flashing twice.Press and hold for 3 seconds to disable the remote control, indica-
ted by the LED flashing just once.
Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to
wash the filters. The alarm is triggered after the Hood has been in operation for
100 working hours. (Reset see the parag. Maintenance)
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
indicating that the filter must be changed; the Metal Grease Filters must also be
washed. The Activated Charcoal Filter saturation alarm comes into operation
after the Hood has been working for 200 hours. (Activation and Reset see the
parag. Maintenance)
T2 T3 T4