Installation - Electrolux EFC6423 Bedienungsanleitung

INSTALLATION

Wall drilling and bracket fixing
Wall marking:
• Draw a vertical line on the supporting wall up to
the ceiling, or as high as practical, at the centre
of the area in which the hood will be installed.
• Draw a horizontal line at 650 mm above the
hob for installation without the back panel, or
at height H (H=height of the visible part of the
panel) for installation with the back panel.
• Place bracket 7.3 on the wall as shown about
1-2 mm from the ceiling or upper limit aligning
the centre (notch) with the vertical reference
line.
• Mark the wall at the centres of the holes in the
bracket.
• Place bracket 7.2.1 on the wall as shown at X
mm below the first bracket (X = height of the
upper chimney section supplied), aligning the
centre (notch) with the vertical line.
• Mark the wall at the centres of the holes in the
bracket.
• Place bracket 7.1 as shown 109,5 mm from the
vertical reference line and 192 mm above the
horizontal reference line.
• Mark the centres of the holes in the bracket.
• Repeat this operation on the other side.
REAR PANEL (OPTIONAL)
The Rear Panel must be fitted before fixing the
hood body and, if it is to be fixed at both top and
bottom, must be fitted at the correct height prior
to installing the bases. As this operation is rather
complex, it should be carried out either by the
kitchen installer or a qualified person who knows
the final dimensions of the units.
For fixing at the top only, proceed as follows:
• Rest the back panel on the base, inserting the
lower plate between the upper surface and the
wall, centring it on the vertical reference line.
• Mark the centres of the two holes in the upper
plate.
• Drill ø 8 mm holes at all the centre points
marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws (4,2 x
44,4) supplied.
• Fix the back panel (where present) using the
12a (4,2 x 44,4) screws supplied.
7.3
7.2.1
109,5 109,5
7.1
ENGLISH 9