14 www.electrolux.com
Replacing the Charcoal Filter
The filter is not washable and cannot be re-
generated. It must be replaced when led S1
flashes or at least every 4 months. The alarm
signal will only light up when the extractor
motor is switched on.
Enabling/Disabling the alarm signal
• In Recirculation Version Hoods, the Filter
Saturation Alarm must be activated on in-
stallation or at a later date.
• Turn the Lights and the Suction Motor off.
• Press button T2 and hold it for 5 seconds
until the LED flashes twice in confirmation:
Alarm signal reset
• Switch off the lights and extractor motor.
• Press T3 and hold for at least 3 seconds,
until LED flashes three times in confirma-
tion.
Replacing the Filter
• Remove the metal grease filters
• Remove the saturated activated carbon
filters as shown (A).
• Fit the new filters (B).
• Replace the metal grease filters.
B
A