Temperature Limitation; Maintenance - HANSGROHE Metropol 15720 Series Montageanleitung

Important! The fitting must be installed, flushed and
tested after the valid norms.
Adjustment
Correction is necessary if the temperature measured at the
take off point differs from the temperature set on the scale.
To adjust temperature proceed as follows: Turn the setting
knob until water at a temperature of 38 C comes out of the
outlet. Loosen screw of setting knob. Remove setting knob
and turn to the 38 C position. Attach setting knob again
and tighten the screw (please see page 65).

Temperature limitation

The temperature is limited by the safety check to 38 C
(100 F). If a higher temperature is required, it is possible to
override the safety stop by depressing the safety button.
Safety Function
The desired maximum temperature for example max.
42 C can be pre-set thanks to the safety function.(see
page 64)
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow by 0,3 MPa:

Maintenance

There is no special maintenance for thermostats.
The non return valves must be checked regularly according
to DIN EN 1717 in accordance with national or regional
regulations (at least once a year).
At this time, please also check the filter (1.1) situated
on the MTC-ther-moelement (1). After assembling the
MTC-thermo-element, it is necessary to check the water
temperature at the take off point as described under the
headline „adjustment". Before the adjustment, please
check, if the warm water supply is activated and the
maximum temperature of the warm water is available at
the take off point.
To guarantee the smooth running of the thermostat, it is
necessary from time to time to turn the thermostat from
total hot to total cold.
10
English
Spare parts (see page 3)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
XXX = Colors
000 chrome plated
max. 80° C
090 chrome plated/gold plated
65° C
400 white/chrome plated
ca. 26 l/min
880 satin chrome
handle for thermostat
handle for thermostat
handle for thermostat PuraVida
handle
handle
handle PuraVida
flange Ø 170 mm
flange PuraVida
sleeve
sleeve
fixing screw
sub plate Ø 170 mm
sub plate Ø 150 mm
thermostat cartridge
noise reduction
non return valve
shut off unit with selector
extension 25 mm
extension 22 mm
extension 22 mm PuraVida
adapter for handle
adapter for handle
screw M5x20
sealing set
36391XXX
38391XXX
11791XXX
96449XXX
96421XXX
95356000
96550XXX
95275000
96439XXX
96446XXX
96454000
96447000
98793000
94282000
94073000
94074000
96509000
13595000
13596XXX
15597000
96451000
96435000
96525000
95037000