REX RFC3110NVD Benutzerinformation Seite 13

Problem
The compressor does not
start immediately after
pressing the "FastFreeze or
"FastCool, or after changing
the temperature.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed cor‐
rectly.
The "FastFreeze or "Fast‐
Cool is switched on.
This is normal, no error
has occurred.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The "FastFreeze function"
or "FastCool function" is
switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FastFreeze function"
or "FastCool function" is
switched on.
There is no cold air circu‐
lation in the appliance.
Solution
Refer to "Closing the door".
Refer to "FastFreeze function"
or "FastCool function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func‐
tion" or "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Store less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "FastFreeze function"
or "FastCool function".
Make sure that there is cold
air circulation in the appliance.
13