GOK ODR Bio Montage- Und Bedienungsanleitung Seite 10

8. CONNECTIONS - FOR OIL FIRING INSTALLATIONS
Inlet and outlet
Type ODR, Type ODR Bio
Type ODRE, Type ODRE-M
You can find the compression fitting installation instructions at
www.gok-online.de/en/download/technical-documentation.
Alternative inlet
Type ODRE-M
Alternative outlet
Type ODRE-M
You can find the screw-in connector data sheet at www.gok-
online.de/en/download/technical-documentation.
9. ASSEMBLY
Before assembly, check that the product is complete and has not suffered any damage during
transport. ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION! The specialised company and the operator must observe,
comply with and understand all of the following instructions in this assembly and operating
manual. For the system to function as intended, it must be installed professionally in
compliance with the technical rules applicable to the planning, construction and operation of
the entire system.
4 / 6
Compression fitting
• optionally compr. fit 6, compr. fit 8, compr. fit 10, compr.
fit 12, compr. fit 15
• according to EN ISO 8434-1 and DIN 2353
Trading name and dimensions acc. to standard
Cylindrical female thread G 1/4 acc. to EN ISO 228-1,
O-ring dimensions 9x2mm, included with delivery
Screw-in connectors, type B acc. to EN ISO 1179-4
Example: Screw-in connector with cylindrical male
thread G 1/4 GOK Type GERB
Trading name and dimensions acc. to standard
Cylindrical female thread G 3/8 acc. to EN ISO 228-1,
O-ring dimensions 14x2mm, included with delivery
Screw-in connectors, type B acc. to EN ISO 1179-4
Example: Screw-in connector with cylindrical male
thread G 3/8 GOK Type GERB
A reinforcement ring must be used with all thin-walled pipes and with
soft pipe materials.
Brass reinforcement rings may not come into contact with aluminium
pipe. Risk of corrosion!
Trading name and dimensions
acc. to standard
Item No. 13 504 50 f