prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
Always descale the appliance when
Service - descale
"Descaling") to avoid a buildup of limes
cale. Limescale residue results in higher
energy consumption.
Daily maintenance
and cleaning
Risk of electric shock
Before cleaning the appliance,
switch it off at the power switch.
Do not use a steam cleaner.
Daily maintenance
1.
Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
2.
Do not use alcoholbased or spiritbased
cleaning agents on the highgloss sur
faces.
3.
Rinse out the water tank (12) with water
only.
4.
Take off the grate (24). Pull out the drip
tray (25). Take off the drip tray panel.
Empty out any water and coffee grinds
(26). Clean the drip tray or put it in the
dishwasher. Do not put the grate (24) or
the drip tray panel in the dish washer.
24
20
Siemens
is displayed (see
25
26
5.
Wipe out the inside of the tray holders.
6.
Clean the milk frother (procedure
described below).
7.
Replace all the parts again.
If the appliance is cold when
switched on with
if it is set to "energy saving mode"
after dispensing coffee, it rinses
automatically. In other words the
pipework inside the appliance is
cleaned by the machine itself.
Cleaning the milk system
Risk of burns
The milk frother (10) gets very
hot. After use, allow to cool down
first before touching.
Clean the milk system immediately after use.
All the parts can also be
put in the dishwasher.
Short rinse for milk system:
1.
In the menu for drink selection, select
Short rise for milk system
start stop
2.
Place a cup under the milk frother (10)
and the end of the milk tube in the cup.
3.
Press
start stop
ance now fills the cup automatically with
water and draws it in again through the
milk tube for rinsing. The rinse procedure
takes about 1 minute.
4.
Empty the cup and clean the milk tube.
English | 37
on off
and press
(8).
(8). The appli
TK76K572 | 09/2008
(2), or