Siemens TK76K572 Gebrauchsanleitung Seite 35

The following setting options are available
to you:
: Turn the knob
> Language
the display language.
> Water hardness
select the required water hardness (1, 2, 3
or 4) (refer also to "Checking and setting the
water hardness").
> Coffee temperature
knob to set the coffee temperature.
> Auto off after
enter the time span after which the appliance
should automatically switch to "energy
saving mode" following the last drink
preparation. A time between 5 minutes and
8 hours can be set. The default time is one
hour, but this can be shortened to save
energy.
: The display contrast can
> Contrast
be set from –20 to +20 with the rotary
knob (4). The default setting is 0.
> Illumination
to on , off or off after 10 minutes
setting).
> Water filter
fi lter is inserted in the water tank (12), it must
be rinsed:
1. Place the water fi lter in the water tank
(12) and fi ll the tank with water up to the
"max" mark.
2. Turn the rotary knob
short rinse for milk system and press
start stop
3. Place a container with a capacity of 0.5
litres under the milk frother (10).
4. Press
start stop
run fi rst through the fi lter to rinse it and
then into the container.
Empty the container. The appliance is ready
to use once more.
Rinsing the fi lter simultaneously activates
the setting for the Change filter
The fi lter is no longer effective when the
Change filter display appears, or at the lat­
Siemens
to select
: Turn the knob
: Turn the
: Turn the knob
: The lighting can be set
(factory
: Each time a new water
to select
START
(8).
(8). Water will now
display.
est after two months. It needs to be replaced
for reasons of hygiene and so that there is
no build­up of limescale (this could damage
the appliance). Replacement fi lters can be
to obtained from retailers or customer service
(see "Accessories").
After every fi lter change the fi lter must fi rst
be rinsed. Proceed as described at the
beginning of this section.
If no new fi lter is used, turn the water fi lter
to setting to
Further entries in the Settings menu:
> Service - descale
descale the appliance, press
(8) and run the descaling programme
(see "Descaling").
> Service - clean
the appliance, press
run the cleaning programme
(see "Cleaning").
> Service - Calc'n'Clean
descale and clean the appliance at the same
time, press
Calc'n'Clean programme
(see "Calc'n'Clean").
> Factory settings
your own settings and reset the factory set­
tings. To activate the factory settings, press
start stop
Off .
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the fi lter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
: If you want to
: If you want to clean
start stop
(8) and run the
start stop
: You can cancel
(8).
English | 3
start stop
(8) and
: If you want to
TK76K572 | 09/2008