Adjusting The Grinding Unit; Checking And Setting The Water Hardness; Tips On Energy Saving - Siemens TK76K572 Gebrauchsanleitung

36 | English
The appliance can also be reset to
the factory settings as follows:
1. Switch the appliance off fully at the
power switch
O/I
5
2. Press < and
time, hold them down, and switch the
appliance on again at the power switch
O/I (1).
The factory settings are reactivated.

Adjusting the grinding unit

The rotary selector (16) on the top of the ap­
pliance adjusts the degree of grinding from
coarse to fi ne as required.
16
Warning:
Adjust the grinding unit only while
it is running. Otherwise the appli­
ance may be damaged.
1. Deploy the appliance fully (see "Deploy­
ment system").
2. In the drink selection menu, select
.
Espresso
3. Press start stop
4. While the grinding unit is running, adjust
the rotary selector (16) from fi ne
coarse or back as required.
The new setting will not
become apparent until after the
second cup of coffee.
Siemens
(1).
> (3) at the same
2 6 3 4
(8).
to
Tip: For dark roast coffee beans, choose a
fi ner grind, for lighter beans a coarser grind.
Checking and setting
the water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly, so that the appli­
ance indicates accurately when the descal­
3 7 8
ing programme should be run. The factory
setting for the water hardness is 4.
You can check the water hardness using the
enclosed test strip or by asking your local
water supplier.
Dip the test strip briefl y in water, gently
shake off any drips, and check the result
after one minute.
Water hardness levels and settings:
Level Water hardness
German (°dH) French (°fH)
1 1­7
2 8­14
3 15­21
4 22­30

Tips on energy saving

The fully automatic espresso machine

switches to "energy saving mode" auto­
matically after one hour (factory setting).
The appliance uses very little power in
"energy saving mode". The default time
of one hour can be shortened (see "Auto
off after" under "Displaying settings").
The appliance then uses even less
power.
If the appliance is not being used, switch

it off at the power switch.
If possible, do not interrupt coffee or milk

froth dispensing. Stopping a process
1­13
14­25
26­38
39­54
TK76K572 | 09/2008