Using The System; Enter Local Program Mode On The Lcd Keypad; Entering The Client Program Mode/User Mode; Entering The Installer Program Mode - Siemens IC60 Bedienungsanleitung

3

Using the system

3.1

Enter Local Program Mode on the LCD Keypad

3.2

Entering the Client Program Mode/User mode

3.3

Entering the Installer Program Mode

Building Technologies
Fire Safety & Security Products
To operate/program the system you have to enter different program modes.
For programming you can use either a PC with programming SW (Sylcom 60), or
trough the Keypad in 2 different ways:
Navigate trough the clear text Menu with the 'arrow keys'
Program all functions with the special programming codes (Installer)
To access any Program mode, it is a prerequisite that the system is NOT armed
<CTRL> <ARM>
In this mode you can program local data, like Keypad name, Names of Zones,
Groups, Users, Language etc.
1. Press the 'CTRL' and 'ARM' button together for 2 seconds.
DISPLAY: Local Mode Kb 1 / User Name
To leave this mode always press and hold 'Prog'
Normally the installer will give you access to the CLIENT mode so you can add,
delete, or change the user codes. If you request it, your installer can provide you
with access to the INSTALLER mode as well.
Press <PROG>
Enter Master code (default is 147258)
1. <ENTER>
To get into INSTALLER mode provided the system is NOT armed
1. Press <PROG>
Enter Master code (default is 258369)
2. <ENTER>
If there is a single long beep at this point and the program LED does not turn on, this means that
you can not access the PROGRAM MODE with your code.
Using the system
9
08.2007