Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
1 . Remove the packaging material and spread
the trampoline (1) on the floor .
2 . Unfold the trampoline as shown in Fig . B . You
must hear the frame sections lock into place .
Attention – Crushing hazard!
Keep fingers away from the frame
joints whilst unfolding.
The frame sections will abruptly snap
into their final position. Hold on to the
frame sections until you hear them lock
into place. Otherwise the frame sec-
tions will snap back into their original
position.
3 . Spread the safety pad (2) out on the floor
with the reverse facing up .
4 . Place the unfolded trampoline over the safety
pad and pull the notches in the safety pad
over the threads in the trampoline (Fig . C) .
5 . Remove the protective caps (1a) from the
trampoline and screw the legs (6 / 7) into
the designated threads on the trampoline
(Fig . C) .
Important: One leg (7) must be installed
between the two reinforced legs (6) to later
install the bar .
Note: Keep the protective caps in a safe loca-
tion for storing the trampoline .
6 . Attach one leg cap (8) to each leg (7); do
not attach leg caps to the reinforced legs (6)
at this time .
7 . Turn the trampoline on its legs .
8 . Attach the leg reinforcements (5) over the
two reinforced legs (6) (Fig . D) .
9 . Attach the two leg caps (9) to the leg
reinforcement (5) and the leg caps (8) to the
reinforced legs (6) .
Use the locking screws (10) to secure the two
leg reinforcements to the two legs (Fig . D) .
10 . Connect the handle sections (3 and 4) to
form a handle as shown in Fig . E .
11 . Insert the ends of the handle into the leg
reinforcements . The holes on the leg rein-
forcements must match with the holes on the
handle .
Attention! Only use the product if the locking
screws are each secured in one of the three ad-
justment holes on the handle! Do not extend the
handle past the mark on the leg reinforcement .
12 . Use the locking screws (11) to secure the
handle .
Note: The safety pad must completely cover all
springs .
Disassembly
Disassemble the product in the reverse order .
1 . Remove the safety pad .
2 . Before folding the trampoline, attach the
protective caps (1a) to the threads on the
trampoline (Fig . B) .
Note: We recommend using two persons to
fold the product .
3 . Place your left foot on the frame, to the left of
the frame joint (1b), and use your full strength
to pull the section of the frame to the right of
the frame joint up toward you .
4 . Fold the two sections of frame as shown in
Figure B .
5 . Slide the two frame joints (1b) together .
Attention – Crushing hazard!
Keep fingers away from the frame
joint whilst folding.
The frame sections will abruptly snap
into their final position whilst folding.
Hold on to the frame sections until you
hear them lock into place. Otherwise
the frame sections will snap back into
their original position.
Adjusting the handle
The handle can be adjusted to three heights
(Fig . E) to fit your body height .
1 . Loosen and remove the locking screws (11)
and adjust the handle to the respective height .
Attention! Only use the product if the
locking screws are each secured in one of the
three adjustment holes on the handle! Do not
extend the handle past the mark on the leg
reinforcement .
GB
11
Werbung
Inhaltsverzeichnis
