Unitec Climate W263 Bedienungsanleitung Seite 10

SETTING THE CLOCK ALARM
1) Press the [ ] 5 key to display the alarm time
for 10 seconds.
2) Within that 10-second window, press the [
key again until an audible signal sounds. The hour
display will start to flash.
3) Use the [+ C/F] 6 and [ - ] (8) keys to change the
figures up or down.
4) Press [ ] 5 again to set the minutes in the
same way as described above.
5) Press [ ] 5 again to confirm. The „AL" and
„Zz" symbols will now be flashing above the
specified alarm time.
6) Use the [+ C/F] 6 and [ - ] 8 keys to toggle
between the „Zz" snooze alarm, „AL" daily alarm
or alarm off (no symbol).
7) To activate the alarm, press the [
Press it again within 10 seconds. A bell symbol
will now appear on the display, meaning that the
alarm is activated. See below for how to deactiva-
te the alarm.
SUNNY PARTLY CLOUDY
The following barometric pressure trends can be displayed using the arrow ( B ) on the main unit's display:
rising
steady
falling
SPECIFICATIONS
Power for main unit:
Type of battery in main unit:
Temperature range of main unit:
Operating temperature:
Temperature display resolution:
English
313502_W263_Manual_130430.indd 10
SNOOZE ALARM
When the alarm goes off, you can use the [SNOOZE]
button 3 to delay the alarm for a further 10 minutes.
Press the [
] 5
off the alarm until the next day.
DISPLAY MEASURED DATA
Press the [MAX/MIN] key 4 to access the maximum
values for indoor, outdoor and soil temperatures.
Press again to display the minimum values. To delete
measurements, hold down the [MAX/MIN] key 4 for
at least three seconds.
WEATHER FORECAST
The system forecasts the weather conditions for the
next 12 to 24 hours based on changes in atmospheric
pressure within a radius of approx. 30 to 50 km (19 to
] key 5.
31 miles) and is 70 to 80% accurate. Because it is not
possible to forecast weather conditions with 100%
accuracy, we cannot be held responsible for any los-
ses that may arise due to incorrect forecasts.
CLOUDY
Power for remote sensor:
2 x 1.5 V Type of battery in remote sensor: 1 x CR2450
2 x AA / LR6 / Temperature range of remote sensor: –20 ºC to +60 ºC
AM3
0 ºC to +50 ºC Signal frequency:
Max. range (in optimal conditions): 30 m (98 feet)
(32 ºF to 122 ºF)
0 ºC to +50 ºC No. of remote sensors:
(32 ºF to 122 ºF) Soil moisture level:
0.1 ºC (32.18 ºF) Protection class for remote sensor: IP44
10
] key 5 – not [SNOOZE] 3 – to turn
RAINY STORMY
(flashing)
1 x 3.0 V
(–4ºF to 140 ºF)
433 MHz
5
1 (dry) – 4 (wet)
30.04.13 16:55