Initial Use; Operation - auna DR-130 Bedienungsanleitung

• Connect the mains adaptor to the DC power socket of the radio to the wall socket.
• Extend the telescopic aerial as far as it can go. Always make sure that the aerial is extended to ensure
the maximum signal strength and the best possible sound quality.
• Press the ON/OFF to turn the radio on from standby. The LCD backlight will light up during the operati-
on of the radio, and begin to scan for the stations. Once the scan has finished; the radio will select the
first alphanumerically found station.
• When the radio is powered on for the first time, it will start „Full Scan" for available Digital Radio sta-
tions. When the scan is completed, the first station (alphabetically) will begin to play.
• To explore the stations that have been found, you can press DOWN or UP button to skip to the next
found station. When you find a station that you would like to listen to, and then press the "VOLUME/
SELECT" button, or after 5 seconds, the radio will shows "TUNING" on the display then auto select the
current station which showed on the LCD.
• Press the ON/OFF button again; the radio will go to standby mode. The display will show the clock.
Do not forget to pull the mains connection out when you're up to leave the house for a longer time.
Long press the INFO/MENU to enter the main menu, and then press DOWN or UP to see the menu list. Press
SELECT to edit. In every menu, change parameters pressing UP/DOWN and save changes with SELECT.
Menu list Options / Functions
PI-# ( in FM mode only) Display of PI number
<Time Set> Set time and date
<Set Backlight> High Level / Mid Level / Low Level
<Sleep Timer> Set Sleep Timers
<Alarm Time> Set 2 separate alarms (Options: Beep / FM / DAB)

Initial Use

Operation

Info Model and software version info („DB220 V1.21")
Main Menu
11