Waeco PerfectPower PP152 Montage- Und Bedienungsanleitung Seite 21

PerfectPower
Electrical cables
If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or wire bushings to prevent damage.
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
2.3 Operating the appliance safely
Caution
e
Note the following basic safety information when using electrical
devices to protect against:
– Electric shock
– Fire hazards
– Injury
Do not operate the device near gas or flammable material; the surface
temperature can reach up to 60 °C.
Operate the device only if you are certain that the housing and the cables
are undamaged.
Make sure the air inlets and outlets of the device are not covered.
Ensure good ventilation.
Do not connect the 230 V output of the inverter (fig. 1 1, page 3) to a
different 230 V source.
Even after the fuse triggers, parts of the inverter remain live.
Always disconnect the power supply when working on the device.
General safety instructions
21