Waeco CA-45 Bedienungsanleitung Seite 25

_CA-45.book Seite 25 Montag, 3. Mai 2004 9:22 09
CA-45, CAB-45
Never check for leaks with an open flame or near sources of ignition.
➤ Check all connections with a leakage test spray.
There are no leaks if no bubbles form.
➤ Ensure that
– The thermostat control for 220 V – 240 V operation (2 2, page 3) is
in the "0" position
– The battery plug is not connected.
➤ Press in the gas control (2 3, page 3) and hold it in for approx. 10 s to
force out any air in the hose connection.
➤ Turn the gas control (2 3, page 3) towards "MAX".
✓ You will hear a regular clicking noise: the Piezo ignition is trying to light
the flame.
When the flame is burning, the cooler is ready for use.
➤ If the flame does not ignite, repeat the procedure.
Tip!
If it is not possible to light the gas with the Piezo lighter due to high
air humidity, you can light the gas burner with a match at the opening
in the back panel of the device when the gas control is pressed in.
➤ Set the desired temperature with the gas control (2 3, page 3).
➤ Check that all hose lines and all connections are in a technically perfect
condition at regular intervals.
➤ To switch off the cooler, first close the valve on the bottle and then turn
the gas control (2 3, page 3) completely shut in a clockwise direction.
Replacing the gas bottle
Only change the gas bottle in well ventilated areas.
Make sure that there are no sources of ignition in the vicinity.
Only change the gas bottle when the cooler is switched off.
➤ Switch off the cooler by completely shutting the gas control (2 3, page 3)
by turning it clockwise.
➤ Completely close the valve on the gas bottle.
➤ Unscrew the valve from the bottle.
➤ Check the condition of the hose line.
Replace the hose line if the material is brittle or porous.
➤ Screw the pressure reduction valve tightly onto the new bottle.
Operating the cooler
25