Waeco CA-45 Bedienungsanleitung Seite 20

_CA-45.book Seite 20 Montag, 3. Mai 2004 9:22 09
Safety instructions
Only use the device in well ventilated areas.
The device may give off a smell for a short time when it is first
operated.
Only operate the device from a single energy source.
Only operate the device when you or another person can
attend to it.
Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Do not fill the inner container with ice or fluid.
WAECO cannot be held liable for damage resulting from
improper usage or incorrect operation.
2.3 Operating the device safely with 12 V DC
The cable between the battery and the cooler must be protected
by a fuse of max. 15 A.
Only use cables with the corresponding cable cross section
(see the table on page 24).
2.4 Operating the device safely with 220 V – 240 V
Only use the connection cable supplied to connect the device
to the AC mains.
Never pull the plug out of the socket by the cable.
If the cable is damaged, it must be replaced by a cable with
the same technical specifications to prevent possible electrical
hazards.
Before starting the device, ensure that the power supply line
and the plug are dry.
Check that the voltage specification on the type plate
corresponds to that of the energy supply.
20
CA-45, CAB-45