Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 445e II TrioBrake Bedienungsanweisung

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or incorrect use can
result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European Community's
Directive. The machine's emission is
specified in the Technical data chapter and
on the label.
Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump.
Refuelling.
Chain oil fill.
Chain brake, activated (right) Chain
brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
1155361-38 Rev.2 2014-11-25

KEY TO SYMBOLS

Symbols in the operator's
manual:
Switch off the engine before carrying
out any checks or maintenance.
CAUTION! The start/stop switch
automatically returns to run position. In
order to prevent unintentional starting,
the spark plug cap must be removed
from the spark plug when assembling,
checking and/or performing
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged when
the chain saw is started.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
–
English 7