Turning On The Power - Mitsubishi Electric PZ-61DR-E Installationsanleitung

9. Turning on the power

Make sure that the remote controller is properly installed according to the instructions in the Installation Manual and that the Lossnay unit
installation has been completed before turning on the power.
(1) When the power is turned on, the following screen will appear.
Please Wait
10%
Normal start up (indicating the
percentage of process completion)
(2) Main display
After the successful startup, the Main display will appear.
Lossnay
Main display
(while the unit is not in operation)
10. Initial settings (Remote controller settings)
<Administrator password is required.>
From the Main display, select Main menu>Initial setting, and make the remote controller settings on the screen that appears.
Initial setting menu
Main/Sub
Clock
Main display
Contrast
Display details
Main menu:
Cursor Page
(1) Main/Sub setting
When connecting two remote controllers, one of them needs to be designated as a sub controller.
[Button operation]
[1] When the F3 or F4 button is pressed, the currently selected setting will appear highlighted.
Select "Sub", and press the SELECT button to save the change.
[2] Press the MENU button to return to the Main menu screen. (This button always brings up the
Main menu screen.)
Notes
· When the power is on for the first time, the Language selection screen will be displayed. Refer
to section 10 (8). Select a desired language. The system will not start-up without language
selection.
Lossnay
12:00 Sun
Main display
(while the unit is in operation)
Initial setting menu (1/2)
· Main/Sub
1/2
· Clock
· Main display
· Contrast
· Display details
-Clock
-Temperature
-Temp. display
12:00 Sun
Outdoor
0°C
Return
20°C
Auto
Supply
15°C
Fan Mode
Initial setting menu (2/2)
· Auto mode
· Administrator password
· Language selection
Note: The initial administrator password is "0000". Refer
- 10 -
Notes
· When connecting two remote controllers, be sure
to designate one as a main and the other as a sub
controller. Refer to section 10 "Initial settings" for
how to make the Main/Sub setting.
· Refer to the Instructions Book for the icons on the
display.
to section (7) "Administrator password setting" for
how to change the password.
Main /
Select:
Main/Sub
Sub
Cursor