Trouble Shooting; Cleaning And Maintenance; Cleaning; Fault Correction - Grizzly ELS 2400 TE Bedienungsanleitung

Trouble shooting

Problem
Device does not start
Device works with
interruptions
Low suction capacity or
suction not present
Small or missing blowing
power
Device works with
interruptions
Cleaning and
maintenance
Pull out the power plug before all work
on the device.
Any work, which is not described in
these directions, should be carried
out by a service station authorized
by us. Employ only original parts.
Possible cause
Mains voltage is not present
Defective on/off switch
Worn carbon brushes
Defective motor
The suction tube is not
properly fitted.
Damaged power cable
Internal loose connection
Defective on/off switch
Collection bag is full
Collection bag is dirty
Selector switch in incorrect
position
Device clogged up or
blocked by foreign bodies
Selector switch in incorrect
position
Airstream regulator in
incorrect position
Foreign body blocks impeller
wheel
Before every use, check the garden vacuum-
blower for obvious deficiencies, such as
loose, worn or damaged parts and for correct
seating of the parts. Replace damaged parts.
Check the bag regularly for wear and tear.
Carry out the following maintenance and
cleaning work regularly. By this means, a
long and reliable life is guaranteed.

Cleaning

Fault correction

Check plug socket, cable, line,
plug and fuse, where appropriate,
repair through electrical specialist
Repair through customer service
Fit the two-piece tube.
Check cable; where appropriate,
replace
Repair through customer service
Empty collection bag
Clean collection bag
Set selector switch to the suction
symbol
Remove plug or blockages (see
chapter Cleaning and
Maintenance)
Set selector switch to the blowing
symbol
Rotate airstream regulator to high
position
Remove blockage (see chapter

Cleaning and Maintenance)

Clean the device in each case imme-
diately after working, since otherwise
GB
53